Anycubic PLA Marble

PLA by Anycubic · Marble (mixed white/grey with mineral particles)

Diameter

1.75mm

Nozzle temperature

200–230°C (rec. 215°C)

Bed temperature

55–65°C (rec. 60°C)

Print speed

20–150 mm/s

Density

1.37 g/cm³

PLA Marble contains genuine marble particles which act as a mild abrasive — consider using a hardened steel nozzle for long prints. The marble filler increases density to 1.37 g/cm³ (vs ~1.24 for standard PLA). Dry before use at 55–65°C for 6–8 hours as specified. The Bambu Lab P2S has an enclosure; keep the enclosure door open or use active ventilation to prevent heat buildup above 35°C, which can cause PLA jams or soft filament feed issues. Max print speed is capped well below the TDS upper limit of 250 mm/s to account for the abrasive filler and maintain surface quality. Retraction distance is set conservatively for direct drive.