Skip to content

    Calibration Wizard

    Step-by-step guided wizards for tuning your 3D printer. Cover flow rate, pressure advance, retraction, temperature, bed leveling, and input shaper — get print-ready settings in minutes.

    Get Filwiz Pro

    Flow Rate Calibration

    Dial in your extruder's flow rate to eliminate under- and over-extrusion. The wizard guides you through printing test cubes, measuring wall thickness, and calculating the correct flow multiplier.

    Parameters tuned:

    • •Flow rate multiplier
    • •Extrusion width
    • •E-steps per mm

    Pressure Advance / Linear Advance

    Reduce corner bulging, blobs at direction changes, and ghosting artifacts by tuning pressure advance (Klipper) or linear advance (Marlin). Prints a calibration pattern and helps you pick the ideal K-factor.

    Parameters tuned:

    • •K-factor / PA value
    • •Print speed
    • •Acceleration

    Retraction Tuning

    Eliminate stringing and oozing by finding the optimal retraction distance and speed for your hotend and filament combination. Direct drive and Bowden setups handled separately.

    Parameters tuned:

    • •Retraction distance (mm)
    • •Retraction speed (mm/s)
    • •Extra restart distance

    Temperature Tower

    Find the sweet spot nozzle temperature for any filament. Print a temperature tower that steps down in 5°C increments and evaluate layer adhesion, surface finish, bridging, and stringing at each level.

    Parameters tuned:

    • •Start temperature
    • •End temperature
    • •Step interval (°C)

    Bed Leveling & Z-Offset

    Achieve a perfect first layer across the full print bed. The wizard walks you through manual mesh leveling, Z-offset adjustment, and baby-stepping for reliable adhesion every time.

    Parameters tuned:

    • •Z-offset (mm)
    • •Mesh grid size
    • •First layer height

    Input Shaper / Resonance Compensation

    Reduce ringing and ghosting artifacts caused by printer vibrations. Guides you through Klipper's resonance testing or manual ADXL accelerometer measurement to find optimal shaper frequency.

    Parameters tuned:

    • •Shaper type (MZV, EI, 2HUMP_EI)
    • •X/Y frequency (Hz)
    • •Max acceleration

    Works With Any FDM Printer

    Compatible with Bambu Lab, Prusa, Creality, Voron, Ratrig, and any Klipper or Marlin-based printer. Each wizard adapts its instructions to your firmware type.